OmniDry 33 “Workhorse” Air Mover OmniDry 33 gives you the lowest amps with the highest air flow.  An outstanding workhorse air mover, the OmniDry is perfect for water restoration as well as speed drying after cleaning.  This 3-speed air mover delivers up to 2200 CFM at approximately 3.9 amps.  Three speeds allow you to control the airflow and the unit also tilts back to deliver airflow at 45 and 90 degrees when needed.  It's also stackable for storage and transport and comes with a 25-foot power cord with a built-in cord wrap. 3-speed, 1/3 horsepower motor Power: 115 VAC, 60 Hz Balanced air flow for quieter operation Lightweight housing is washable and chemical resistant Ergonomic handle Long-Lasting Bearing Motor - (not a sleeve motor) See comparison table below 1 Year Warranty on Parts & Labor 2 Year Parts Only Warranty 7 Years Warranty on Housing Speed RPM Amps High 1050 3.9 Medium 850 3.0 Low 650 2.45    Ball Bearing Motors vs. Sleeve Bearing Motors Criteria Ball Bearing Sleeve Bearing Fan Longevity Longer life Shorter life Heat Endurance Higher Lower Fan Mounting Options Vertical, Shaft Center Line Parallel, Perpendicular Vertical Noise Emission Quieter at High Speeds Quieter at Low Speeds in Early Life Parts Precision Non-precision Lubricant Less Evaporation More Evaporation Contact Point Line Cost More Expensive Per Unit Less Expensive Per Unit ACCESSORIES: AC511 - OCTI-DRY STANDARD